1. Using my Scor - Pal and an 8.5 x 11 inch pice of white cardstock. I scored at 2.5and again at 6.75 inches. Fold. Then I trimmed the excess away from the two flaps so that they would meet in the front middle. Then I ran my cardstock through my Cuttlebug with my largest Spellbinders Nestibilities Heart. **** Note if you attempt to make this card, be careful with the placement of the Nestie on the edges of the cardstock, you need to have enough room to create your hinges. Don't Cut Them Off! :O)
2. I used a piece of decorative paper and the next smaller Nestie and ran it though the Cuttlebug. Then I cut it in half and this made my card cover.
3. I printed my digis from Simple Doodles; the bee and the sentiment and big red heart inside. I colored the bees with my Copics and I added some silver glitter gel pen to the wings and some gold Spica to his belly and to the inside sentiment. My little bee is suspended on wire. 4. I cut a blue heart from the next smaller Nestie and then I also used it to cut my inside sentiment. I layered the white on the blue and layered them both on top of my Simple Doodles heart. The heart had three little black dots on the lower right hand side, I punched holes and added 2 white and a black brad. I used the gold Spica to drip honey on my sentiment.
5. I embellished the front flaps with my Simple Doodles Bee, Imaginisce flowers, rhinestones and some stickers from Keep in Touch kits.
Betty aka ZacksNana